Smokestack 1/8th

Experimental Smokestack

Reg Price: $365

Sale: $259
Domestic shipping: $FREE
International Priority Shipping: $39 (Charges are approximate. We will invoice for international shipping separately.

**International shipping charges are estimated. We will invoice you for the shipping once we can determine the exact cost to your country. Feel free to message us with any questions.

Please Read: Recently I had a couple of these put together. I was testing the idea to see how it worked with eurorack. We put 1/8th jacks on them. NO 1/4″ jacks on this one!  The pedal is exactly the same as the guitar pedal. The only difference is the jacks. It works pretty well in the eurorack format but you do still need a GPI (Guitar Pedal Interface) for full eurorack integration.

More about the Smokestack pedal.


    • This pedal has two separate effects circuits‭ with their own independent outs. ‬On the left side is the Octavia pedal with two different circuits‭. ‬On the right is a distortion pedal‭. ‬The meter can switch between monitoring ether of the pedal circuits‭.‬
    • The Smokestack: is a double pedal that can be used in a number of different ways. Since the octave effect is mixable and can be completely eliminated. On the smokestack side of the pedal it can be dialed to a Clean boost or two different distortions. With a patch cable you can run one of the pedals into the other for a completely different take.
    • Octavia: The top distortion controls the gain‭, ‬distortion and drive of the Octavia clone‭ ‬“Smoke”‭. ‬The bottom distortion controls the distortion of the RML octave circuit‭ ‬“Stack” The‭ ‬“Oct-o”‭ ‬knob controls the amount of the octave effect‭. ‬Volume will control the overall output of the pedal‭.‬
    • War on toggles: I’m not a big fan of toggle switches. Where I can replace them with a potentiometer I will. The “smoke/stack” knob is an ether/or selector. Sometimes a balance can be found but it is not intended to mix the two distinct sounds. All the way to the left for the original octavia clone. All the way to the right for the RML octave fuzz circuit.This also applies to the distortion circuit on the right side of the pedal. “Texture” has 3 settings. Turned all the way to the left for silicon clipping. Center for a loud more mid range sound. Turn all the way to the right for germanium clipping.
    • Power Supply: Use a 9-volt‭, ‬negative-tip power supply‭. ‬18volt will sound better and provide more dynamics‭.‬ Power supply not included.

***All purchases done with PayPal


johnathan May 29, 2019 Uncategorized